PP is a semi-crystalline material. It is harder and has a higher melting point than PE. Since the PP temperature of the homopolymer type is very brittle when it is higher than 0 ° C, many commercial PP materials are random copolymers of 1 to 4% ethylene or a clamp copolymer of a higher ratio of ethylene. The copolymer type PP material has a low heat distortion temperature (100 ° C), low transparency, low gloss, low rigidity, but has a stronger impact strength.

The strength of PP increases as the ethylene content increases. The Vicat softening temperature of PP is 150 °C. Due to the high degree of crystallinity, this material has excellent surface stiffness and scratch resistance. There is no environmental stress cracking problem in PP. The PP is usually modified by adding glass fibers, metal additives or thermoplastic rubber.

La tasa de flujo de PP tiene un MFR que varía de 1 a 40. Los materiales de PP con bajo MFR tienen mejor resistencia al impacto pero menor elongación. Para materiales del mismo MFR, la resistencia del tipo copolímero es mayor que la del tipo homopolímero. Máquina de reciclaje y peletización de productos en copos de PP y PE

Due to crystallization, the shrinkage rate of PP is quite high, generally 1.8 to 2.5%. And the direction uniformity of shrinkage is much better than materials such as PE-HD.

The addition of 30% glass additive can reduce the shrinkage to 0.7%. Both the homopolymer type and the copolymer type PP materials have excellent moisture absorption resistance, acid and alkali corrosion resistance, and solubility resistance. However, it is not resistant to aromatic hydrocarbons (such as benzene) solvents, hydrogen chloride (carbon tetrachloride) solvents, and the like.

PP does not have oxidation resistance at high temperatures like PE, and it is harmful to the human body.

Los vasos desechables utilizados en la vida diaria están generalmente hechos de plástico pc y pp.

El PC es un material de ingeniería amorfo con una excepcional resistencia al impacto, estabilidad térmica, brillo, inhibición bacteriana, propiedades retardantes de llama y resistencia a las manchas. La brecha del PC

La resistencia es muy alta y la tasa de contracción es muy baja, generalmente del 0.1% al 0.2%. El PC tiene buenas propiedades mecánicas, pero las características de flujo son malas, por lo que esto

El proceso de moldeo por inyección de materiales es difícil. Al elegir qué material de PC de calidad utilizar, debe basarse en las expectativas finales del producto. Si la pieza de plástico requiere alta resistencia al impacto, entonces use un flujo bajo.

Material PC cinético; por el contrario, se pueden utilizar materiales PC de alta tasa de flujo para optimizar el proceso de moldeo por inyección.

PP polipropileno: temperatura de fusión: 220~275 °C.