PP is a semi-crystalline material. It is harder and has a higher melting point than PE. Since the PP temperature of the homopolymer type is very brittle when it is higher than 0 ° C, many commercial PP materials are random copolymers of 1 to 4% ethylene or a clamp copolymer of a higher ratio of ethylene. The copolymer type PP material has a low heat distortion temperature (100 ° C), low transparency, low gloss, low rigidity, but has a stronger impact strength.

The strength of PP increases as the ethylene content increases. The Vicat softening temperature of PP is 150 °C. Due to the high degree of crystallinity, this material has excellent surface stiffness and scratch resistance. There is no environmental stress cracking problem in PP. The PP is usually modified by adding glass fibers, metal additives or thermoplastic rubber.

Le débit de PP a un MFR allant de 1 à 40. Les matériaux PP à faible MFR ont une meilleure résistance aux chocs mais une élasticité inférieure. Pour des matériaux ayant le même MFR, la résistance du type copolymère est supérieure à celle du type homopolymère. Machine de recyclage et de granulation de flocons de PP PE

Due to crystallization, the shrinkage rate of PP is quite high, generally 1.8 to 2.5%. And the direction uniformity of shrinkage is much better than materials such as PE-HD.

The addition of 30% glass additive can reduce the shrinkage to 0.7%. Both the homopolymer type and the copolymer type PP materials have excellent moisture absorption resistance, acid and alkali corrosion resistance, and solubility resistance. However, it is not resistant to aromatic hydrocarbons (such as benzene) solvents, hydrogen chloride (carbon tetrachloride) solvents, and the like.

PP does not have oxidation resistance at high temperatures like PE, and it is harmful to the human body.

Les gobelets jetables utilisés dans la vie quotidienne sont généralement fabriqués en plastique PC et PP.

Le PC est un matériau d'ingénierie amorphe avec une résistance aux chocs exceptionnelle, une stabilité thermique, un brillant, une inhibition bactérienne, des propriétés ignifuges et une résistance aux taches. L'écart du PC

La résistance est très élevée et le taux de retrait est très faible, généralement de 0,1 % à 0,2 %. Le PC a de bonnes propriétés mécaniques, mais les caractéristiques d'écoulement sont médiocres, donc cela

Le processus de moulage par injection des matériaux est difficile. Lors du choix du matériau PC de qualité à utiliser, cela doit être basé sur les attentes finales du produit. Si la pièce en plastique nécessite une haute résistance aux chocs, alors utilisez un faible débit.

Matériau PC cinétique ; à l'inverse, des matériaux PC à haut débit peuvent être utilisés pour optimiser le processus de moulage par injection.

PP polypropylène : température de fusion : 220~275 °C.