With the growing popularity of the plastic recycling industry, the application of the plastic granulator machine (also known as the plastic pelletizing machine) is increasing rapidly. During daily use, waste plastic pelletizer machine users may encounter some glitches. This requires timely analysis of the cause and troubleshooting. Here is an explanation of its common faults and solutions.

Plastik granülatör makinesine kısa bir giriş

plastik peletleme ekipmanı, atık plastik peletleme makinesi olarak da adlandırılır. Plastik film geri dönüşüm üretim hattındaki en önemli makine olarak, genellikle plastik geri dönüşüm fabrikalarında kullanılır. Plastik granülatör, enerji tasarrufu, yüksek verimlilik, kararlı performans, kolay kullanım ve bakım gibi özelliklere sahiptir.

plastik granülatör makinesi
plastik granülatör makinesi

5 Yaygın arıza ve sorun giderme yöntemleri

Aşağıda bir plastik pelet yapma makinesi için genel sorunlar ve bunlara karşılık gelen çözümler bulunmaktadır. Umarım aşağıdakiler, plastik granül yapma makinesini kullanırken size yardımcı olur.

1. Plastik pelet makinesinin ana motoru dönmüyor veya aniden kapanıyor.

  • Reasons: unstable power supply voltage or poor contact; insufficient heater heating or a heater does not work, which makes the motor overload due to excessive torque
  • Treatment methods: check the main motor circuit connection of the plastic granulator machine; check the temperature display of each section of the heater, and check whether the heater has poor contact or damage.

2. Plastik pelet yapma makinesinin ana motoru dönüyor, ancak vida dönmüyor.

  • Causes: The transmission V belt becomes loose, wears and slips; or the safety key becomes loose or disconnected.
  • Troubleshooting methods: adjust the center distance of the V-belt, tighten the belt, or replace with a new V-belt; check the safety key, analyze the cause of the break, and replace the safety key.

3. Pelet makinesinin vidası normal çalışıyor, ancak malzeme boşaltmıyor.

  • Reasons: the feeding of the hopper is not continuous; or there is a foreign object blocking the feeding port; or a metal hard object falls into the screw groove to block the screw groove, and the material cannot be fed normally.
  • Solutions: The troubleshooting method of this failure: increase the feed volume to keep the screw feeding continuously; stop the machine to check and remove the foreign matter in the feed port. If it is confirmed that there is a metal foreign body falling into the screw groove, stop the machine immediately to remove the screw and remove the metal foreign body.

4. Plastik granülatör makinesi, havalandırma deliğinden malzeme alıyor.

  • Causes: there are impurities in the raw materials, or the feed speed is too fast to make the screw extrusion unstable, or the plasticization temperature is not enough.
  • Treatment method: clean the raw materials before feeding or replace the filter screen, or reduce the feeding amount to make the screw extrude smoothly, or increase the plasticizing temperature. However, the temperature should not be too high to prevent burns to the plastic and affect the quality of production.

5. Ana motor torku çok düşük

  • Reasons: the feed system failure caused the twin-screw idling.
  • Solution measures: Check whether the additive system or the main material feeding system is faulty, and clean the blockage of the plastic granulator.

Sonuç olarak, plastik geri dönüşüm peletleme makinesinin normal performansını sağlamak için hataların zamanında analiz edilmesi ve makul önlemlerin zamanında alınması gerekmektedir.