Operating an efficient metal recycling facility requires equipment capable of rapid volume reduction. The Shuliy SL-Y81 series scrap metal baler is engineered for continuous industrial operations, processing loose, bulky metal waste into standard-sized blocks. By decreasing material volume, facilities directly cut transportation frequency and prevent oxidation loss during smelting.

Hydraulic Baling Press Mechanics and Structural Data

Sustained compression of irregular metals demands high structural integrity. The core chassis of this Hydraulic baling press consists of a 30mm thick main steel plate for impact absorption. The internal compression chamber is fully lined with 8mm NM400 wear-resistant plates, combating the high-friction environment created when packing raw materials.

To prevent jams caused by overfilling, the machine integrates Cr12 alloy cutting tools on both sides of the lid chamber. When the lid cylinder initiates the lock-down phase, these blades cleanly shear off any excess material. Because of this robust shearing capability, the machine frequently operates as a dedicated Waste iron baler, handling rigid materials like steel shavings and heavy pig iron blocks without mechanical stutter.

Model Specifications: 250-Ton Heavy Duty Metal Baler

Facility managers require specific output data for accurate layout planning. The standout configuration in our lineup is the Shuliy SL-Y81-2500, a 250-ton heavy duty metal baler capable of processing 4000 to 6300 kg of metal per hour.

This specific Metal compactor utilizes dual 22 kW motors driving two HY80YCG hydraulic pumps (100L/M each). The main cylinder provides 2500 KN of nominal thrust, converting loose scrap into dense 500x500mm geometric blocks weighing between 300 kg and 600 kg. Despite the immense force applied, the overall machine standardizes a single compression cycle to approximately 120-150 seconds.

For facilities integrating this heavy-duty scrap metal baler, the dimensions stand at 5200×2500×1900 mm. Crucially, the frame is formulated to negate the necessity of foundation foot screws, allowing exact floor positioning based on feed logistics.

Maintenance Guidelines for the Scrap Metal Baler

Sustaining the maximum push power of your Metal scrap briquette machine requires strict hydraulic fluid management. If system pressure drops unprompted, technicians should assess the suction line filter for particulate blockages or examine the relief valve damping hole.

Standard upkeep for the Horizontal metal baler includes cleaning and lubricating the slide and central knife monthly, and injecting fresh grease into all bearings quarterly. Additionally, the hydraulic oil volume must be maintained at the correct level—overfilling risks submerging the microswitches, which can cause the scrap metal baler lid controls to become unresponsive.